Dan's Orbiter page
Orbiter English => Orbiter English => Topic started by: briane13168 on 08 May 2012, 17:08:35
-
Hi all, I'm new to Orbiter and have just started trying the 1st mission flying the DG to the ISS. I'm a real world pilot so I'm quite comfortable with the surface modes and instruments and I'm a huge Space Shuttle fan so I know a lot of the terminology for spaceflight....but knowing the terminology and executing a flight are 2 different things... I'm having all kinds of issues getting to the rendevous with the ISS. I have been using the help system (ALT-F1) while in flight and it's just not getting me there and I'm following it closely. Here's the issues I've had:
1) On initial orbit entry I am cutting main engines at the prescribed ApR of 6.731 but in the help it says that corresponds to an altitude of 360KM and it's not even close
2) Once I perform my orbit insertion I get a good circular orbit but my speed is still well below the ISS's speed and I end up having it chase me over almost and entire orbit instead of me catching it
3) When I do the synching of the orbital planes I'm usually with the 5 degrees specified and can get them in synch within the first two nodes but my speed keeps dropping so the station keeps pulling further away
4) Finally, I have yet to even get close to a rendevous since I end up in an oribt too high generally to have any intersections
Any tips or tricks to getting that orbit right the first time so I can get a shot at that rendevous would be great!!
Thanks!